Good advice.. for the test, i used one of my kitchen double-sinks as the reservoir and a blender as my measuring container that i had my cohort keep at about the same level in the non-filled section sink.
Anyways, it took 7.5 seconds on average to fill 1 liter, and 13 seconds to fill 1 liter after going through the storm block. i had to use 12 inches instead of 6 inches for the input/out lines in order for everything to reach.
Quote:
|
Originally Posted by billbartuska
Height is important in your testing, Water going in at the same height (above the floor for instance) as the water coming out. That will eliminate pump head considerations in comparing your tests to each other. If the pump has to "lift" the water farther in one test vs another that will skew the results. A small point, but something to consider
|