Pro/Forums - View Single Post

blue68f100 · 11-17-2005, 07:59 PM

Do you know what hardware version it was before it went south? This may need setting.
I was looking at a snap document on setting them up from a bare unit. They were able to tell if a unit was not correctly configured by looking at the serial No. hardware and ram.
There are 3 option for drive setup, individual (JBOD), mirror (1) and span (0) . But I don't know if it going to help in this case.
Have you tried setting the SN and model at he same time with the bios unlocked?
There is a "/force" cmd, that is attached to the end of a cmd. You might try it.

11-17-2005, 07:59 PM	#4
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	options Do you know what hardware version it was before it went south? This may need setting. I was looking at a snap document on setting them up from a bare unit. They were able to tell if a unit was not correctly configured by looking at the serial No. hardware and ram. There are 3 option for drive setup, individual (JBOD), mirror (1) and span (0) . But I don't know if it going to help in this case. Have you tried setting the SN and model at he same time with the bios unlocked? There is a "/force" cmd, that is attached to the end of a cmd. You might try it. Last edited by blue68f100; 11-17-2005 at 08:13 PM.