Yep, I realize that (re: cal curves).
So... (schedule 40) 3/4 PVC tee, then 3/4" to 1/2" adapters (glued), then 3/8" ID tubing and 6" Silicone tubing.
I like that setup.
We're still going to have some variations, unless you can detail the setup here (i.e. protrusion of the pressure port inside the tee, protrusion of the temp probe and at what depth). Am I just being picky?
When you state 6" OAL connection tubing, what precisely does that mean? Does that include the barb overlap?
Bill, you picked this arrangement, but I can live with a schedule 40 tee, with a tapped pressure port as you have (I'm assuming it doesn't protrude inside the tee?). I would have proposed schedule 80 parts, which are threaded.
Should we go into ID variations of barbs, or agree on a single spec and/or supplier? Or ignore as irrelevant?
|