Lights and image file
If you still have the org 10gig drive, see it it boots. If it does I can give the the detalis to copy it's boot tracks to the new one.
Make sure you set the hard disk to master or what ever the original was.
What are the lights doing (sys & disk) on the front of the snap? If the disk light is solid, it may be doing some disk repair.
You may need to reset the unit back to factory settings after installing.
Then use assist to do the initial setup.
Depending on which version of the 1000 you have you may need to use the 2200 img file.
David
Last edited by blue68f100; 11-23-2005 at 01:49 PM.
|