Ok, the original hard drive I have tried to copy it over to the drive I want to replace it with. When I finished copying over the original hard drive I tried the drive I just copied the image to but it didn’t work. I then tired the original hard drive and that no longer works either. So I must of messed something up when copying over the original image.
I have already reset the server back to factory settings when I tried the drive using the DD command.
When I installed the DD command hard drive into the snap and powered it up after like 1min the lights would start blinking normally like if it was working. But about 1min later when I could view the snap online the hard drive activity light would go off.
I also have an image of a 2200 snap server I will try it now and see if it works.
Thanks
Rick
|