Pro/Forums - View Single Post

jaydee · 11-30-2005, 01:53 AM

If it isn't an endmill then not sure what it is. I have not seen a saw of any kind leave a tailing like that only endmills running at the wrong feed rate/RPM ratio. Saws usually leave a clean cut. They are usually not that precise either.

Anyway I digress.

11-30-2005, 01:53 AM	#388
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Re: Apogee from Swiftech... If it isn't an endmill then not sure what it is. I have not seen a saw of any kind leave a tailing like that only endmills running at the wrong feed rate/RPM ratio. Saws usually leave a clean cut. They are usually not that precise either. Anyway I digress.