Pro/Forums - View Single Post - product testing today

bigben2k · 12-01-2005, 08:33 PM

Darn, mine's not going to have any fittings. On to McMaster...

I hear you about milling the IHS. It's not an easy job, simply because you have to have a solid mill, and a beefy motor, to run a 1mm endmill, even though it's only a 0.6mm depth. I only know that Fettig is so equipped.

I suggested contracting someone to groove all of these IHS for us...

12-01-2005, 08:33 PM	#33
bigben2k Responsible for 2% of all the posts here. Join Date: May 2002 Location: Texas, U.S.A. Posts: 8,302	Re: product testing today – who is being served ? Darn, mine's not going to have any fittings. On to McMaster... I hear you about milling the IHS. It's not an easy job, simply because you have to have a solid mill, and a beefy motor, to run a 1mm endmill, even though it's only a 0.6mm depth. I only know that Fettig is so equipped. I suggested contracting someone to groove all of these IHS for us... __________________ WBTA (Water Block Testing Alliance) Nordic Hardware WC 101