Quote:
|
Originally Posted by bigben2k
Darn, mine's not going to have any fittings. On to McMaster...
I hear you about milling the IHS. It's not an easy job, simply because you have to have a solid mill, and a beefy motor, to run a 1mm endmill, even though it's only a 0.6mm depth. I only know that Fettig is so equipped.
I suggested contracting someone to groove all of these IHS for us...
|
I could do it on mine but I am not going to simply because of liability and I don't have the time.
This brings me to the next question of the cost of the probe and the meter that it will take for this measurement?