Quote:
|
Originally Posted by BillA
no Ben, no heat die is any part of this discussion
no pH, ditto
...
refocus
if the goal is a CPU based testing system, then it could be considered in 2 parts:
1) grooved CPU and TC thermometer, CFxxx and DOW sensors for air (water optional) - suitable for sink or kit testing, components by substitution
2) as above plus flow and pressure measurement capability - to create parametric performance curves for components
lets focus on #1 only for now
|
Quote:
|
Originally Posted by Albigger
Not in house, for sure. May be easier if we source a machinist or two, even better if we get mulitple reviewers to commit and send many procs to be done at the same time. I fear this may be unlikely, depends on cost though...
|
Then could it be an option to provide custom made IHS, and already grooved, according to specs?
People would then cap off their AMD 64 cpu's, substitute their original IHS for these, and the fear of damaging the processor if one would attempt to groove the IHS would disappear.