Ok So I have decided on the following components after much discussion in my other thread in this section:
Everything will be 1/2" tubing.
Rads: 120.2 and a PA160
CPU: Storm
GPU: Danger Den SLI
Pump: MCP655
Fans: TBD
Tubing: Clearflex or Tygon
Layout will be as below, with no possible way of moving things around. So please do not suggest that i move rads to other places.
Some concerns of mine:
1) Will the pump have enough power to run this loop?
2) Will it matter what order I place the components in or is the shortest route the best bet?
3) Would it makes sense to try to route the PA160 between the CPU and GPU even though it may increase the length of the run?
4) Will intake from the PA160 have any effect on overal system temps and possibly hurt performance since the 120.2 is pulling air out of the system?