MCW55 in SLI tubing solution
That bend (180 deg) from block to block is tough to get right W/O kinks, coolsleeves, wires, or ties.
Try this: Get about 1 ft of 1/2" CPVC (the beige stuff, the tubing fits over it easier), cap one end, fill it with sand (dry sand!) cap the other end (no need to glue the caps) heat it up over a stove and bend it into a U around something with the proper radius, cut to length, add hose and clamps. The sand keeps the CPVC from kinking. When you bend it, you'll get a nice, even 1/2" ID bend.
__________________
My new rig....
Intel SE440BX-3, PIII 550 (@ 680)
MX440 275/332 (@ 350/400) and 3DFX Voodo 5 5500 160/160 (@180/180)
Two Opticals and 120 gigs (w/28gigs in RAID0) on 4 Maxstors
Last edited by billbartuska; 12-29-2005 at 02:48 AM.
|