Pro/Forums - View Single Post - "Nazca"

ricecrispi · 01-15-2006, 01:54 PM

Better off making a 4 pattern channel over 8 or 10 pattern. More headaches and work with no improvements in anything.

The middle plate is almost impossible to line up the nozzles correctly with manual work. Plus, its pointless making the accel nozzle in a circular pattern because most dies are rectangular.

Have the accel plate into a single large colum of 3-4 nozzles with each row at the same angles. You still get the sweeping arch idea but its easier to mill.

Easier if you cut out the center dividers and make them into channels. Design an accel plate with cross pattern like aquaextreme mp blocks.

01-15-2006, 01:54 PM	#4
ricecrispi Cooling Savant Join Date: Jul 2005 Location: california Posts: 429	Re: "Nazca" - Waterblock Concept Better off making a 4 pattern channel over 8 or 10 pattern. More headaches and work with no improvements in anything. The middle plate is almost impossible to line up the nozzles correctly with manual work. Plus, its pointless making the accel nozzle in a circular pattern because most dies are rectangular. Have the accel plate into a single large colum of 3-4 nozzles with each row at the same angles. You still get the sweeping arch idea but its easier to mill. Easier if you cut out the center dividers and make them into channels. Design an accel plate with cross pattern like aquaextreme mp blocks.