Quote:
Originally Posted by JFettig
Why dont you get some brass tube?
|
Oddly enough it comes in the same size. I didn't think it did.
Would it be better to get brass rod that's 3/64 OD then drill our the center or get 1/16" OD tubing and then sand the outside down to 3/64?
If only I could remember what my uncle taught me about casting brass cartridge shells...
Quote:
Originally Posted by JFettig
I doubt you'll be able to turn those little tiny peices of tube down to a smaller diameter.
|
I was thinking it would be easier to put the pieces in a drill press and use sandpaper or a sanding stone to reduce the outer diameter where I need to.