View Single Post
Unread 01-20-2006, 07:25 PM   #33
clocker
Cooling Neophyte
 
clocker's Avatar
 
Join Date: Jun 2004
Location: Denver, CO
Posts: 29
Default Re: "Nazca" - Waterblock Concept

Quote:
Originally Posted by Captain Slug
I was thinking I would point-drill precisely where each bend was going to take place. Then I would just need to mill the paths between the drilled holes.
Much easier with a rotary table.
They aren't that expensive (think Chinese) and, unless you are magic, your plan on drilling/fixturing/refixturing/more drilling, etc. is not gonna work, especially at the sizes/tolerances we're talking about here.
Seriously....rotary table.
clocker is offline   Reply With Quote