Pro/Forums - View Single Post - Snap Server 2200: one disk died in a Mirror config

blue68f100 · 01-24-2006, 08:47 AM

If the system light and disk light are blink in tandem, that means the unit is service mode. Press the reset button 4 times to clear password and all settings. It should blink back at you 4 times. Then Press and Hold the reset button till both the SYS and Disk lights go out, then release the reset button. The snap will reboot, then use assist to do the setup.

3 blinks clears PW only.

Reseting the snap will not change the drive configuration. ( JBOD, Raid 0 & 1).

If you go over to 5, just keep pushing the reset button till you get the proper blinks. "DO NOT REBOOT WITH 5 BLINKS" This is firmware update mode.

If you were running raid 0 stripping, all data will be lost on a failed drive. If this is the case you may have to reload the hd image. The 2200 can boot from any drive. I do not know it the os is stored on both drives during Raid0, I suspect not.

01-24-2006, 08:47 AM	#4
blue68f100 Thermophile Join Date: Jul 2005 Location: Plano, TX Posts: 3,135	Re: Snap Server 2200: one disk died in a Mirror config If the system light and disk light are blink in tandem, that means the unit is service mode. Press the reset button 4 times to clear password and all settings. It should blink back at you 4 times. Then Press and Hold the reset button till both the SYS and Disk lights go out, then release the reset button. The snap will reboot, then use assist to do the setup. 3 blinks clears PW only. Reseting the snap will not change the drive configuration. ( JBOD, Raid 0 & 1). If you go over to 5, just keep pushing the reset button till you get the proper blinks. "DO NOT REBOOT WITH 5 BLINKS" This is firmware update mode. If you were running raid 0 stripping, all data will be lost on a failed drive. If this is the case you may have to reload the hd image. The 2200 can boot from any drive. I do not know it the os is stored on both drives during Raid0, I suspect not.