how to you think this block would perform compared to a swifttech apogee
would their be good water flow and would i need to rough up the inside for more turbulence
how big of a piece of copper is needed for a cpu i have a 2 x 4 1/2 inch thick would that be enoegh
if you have any designs that will fit on a 939 board and that can be done with a drill press and a dremel i would be grateful
oh a one more thing i'm going to try to design a gpu water block for my 7800gtx and i was wonder how far are the mount holes and if you have any designs that would be appreciated