Pro/Forums - View Single Post

Captain Slug · 01-28-2006, 03:18 AM

It's not hard to get the holes drilled precisely if you mark effectively by using an X-acto knife, carpenters square, and a really good mm and inch ruler to find the right dimensions. Then just center punch and drill the holes with a drillpress then tap them for the bolts you want to use.

Slot 1 processors don't comparatively produce much heat so anything more complicated than a cross-drill block would probably be more hassle that it's worth.

01-28-2006, 03:18 AM	#3
Captain Slug Cooling Savant Join Date: Jan 2006 Location: VA Posts: 129	Re: Slot1 waterblocks? It's not hard to get the holes drilled precisely if you mark effectively by using an X-acto knife, carpenters square, and a really good mm and inch ruler to find the right dimensions. Then just center punch and drill the holes with a drillpress then tap them for the bolts you want to use. Slot 1 processors don't comparatively produce much heat so anything more complicated than a cross-drill block would probably be more hassle that it's worth.