Pro/Forums - View Single Post - Finally finished my baseboard heater setup

JamesAvery22 · 02-01-2006, 10:12 AM

At a quick glance the front housing of the head looks ok. Do I need to replace that AND the impeller? Or just the impeller?

If I take the head off the motor sounds fine. Slight hum. Of course when I first got it, the motor alone was pretty noisy. Got some lithium grease and greased up the bearings and it quieted down right away.

Ive been looking for the Z series impeller and can'd find it. All the places that sell replacement impellers don't sell the high head ones. Can I purchase right from Iwaki?

02-01-2006, 10:12 AM	#13
JamesAvery22 Cooling Savant Join Date: May 2004 Location: Northern VA Posts: 383	Re: Finally finished my baseboard heater setup At a quick glance the front housing of the head looks ok. Do I need to replace that AND the impeller? Or just the impeller? If I take the head off the motor sounds fine. Slight hum. Of course when I first got it, the motor alone was pretty noisy. Got some lithium grease and greased up the bearings and it quieted down right away. Ive been looking for the Z series impeller and can'd find it. All the places that sell replacement impellers don't sell the high head ones. Can I purchase right from Iwaki? __________________ Stabbing. My Heatware