Well my itch got the best of me. I sourced out a hungry machinist to have the ultimate reservoir made. In my almost 5 years of water cooling, I have never used a reservoir, but, for my current build I wanted one, but nothing suited me. You may recall my thread
HERE on the solid brass res I aquired. I love the brass res, but it has some shortcomings. You can not remove the glass without dismounting the whole res, big problem IMO. Second, it weighs nearly 4 lbs! Third, the barb placement is no good, and there are not enough of them. Anyway, this new res I had made I have coined 'DelRez' as it is made out of delrin. It very much resembles the aquatube made by Aqua Computer out of Germany. The aquatube is aluminum though, so not an option. Anyway, it uses G 1/4" (BSPP 1/4") thread which is identical in size to all the new swiftech thread (1/4" NPSM). There are 2 reasons why I chose this size, first, Danger Den is switching to them, they have new barbs called 'Perfect Seal' which use the same thread and are o-ring sealed. Second, innovatek's res uses G 1/4" as well and there are some way cool addons that can be put in this res. Temp sensor, LED's etc. All fittings including the plugs are o-ring sealed, no goop or tape necessary. Anyway, I'll stop boring you and show you some pics. Oh, I have 2 mounts, 1 for mounting in the top of the case and one to mount in the 5.25" bays (takes 2 slots). I decided to go with diamond plate for the mounts, not sure if I will leave it polished or spay it black.
Bay Mount:
Top Mount: (The plate is 5" x 5" which IMO is too big... will be making 4x4 or so)
