Quote:
|
Originally Posted by laxman
well I can tell you my proposed specs at the moment for your review:
Iwaki 30 rzt
He 120.3
Minco heater http://www.minco.com/order/country.a...%3fPN%3dHR5293
Swissflow flow meter sf800
Digitec 5810 Thermometer (ordered)
Dalec RTD thermometer (soon to be ordered), for calibration and a little more accuracy then the Digitec
fluke 8050
4 PRTs 100 ohm
1 thin film RTD ohm for Omega
2 YSI probes
barton 247c Dp meter (0-600" wc or about 0-20 psi) |
Hi Josh,
You mentioned earlier that you didn't plan to use a "chiller" and you have a He 120.3 listed in your equipment list - how do you plan to control the water temp going into the WB? For me, scoring a Haake chiller was the turning point of setting up a WB test system. Temp, flow, dP are all important but you need some way to control the WB inlet temp as well (IMHO a raddy isn't going to give you the accuracy or control you need /are looking for).
Good luck with your project and let me know if I can be of any help. I look forward to having some one else in the pool...
