Pro/Forums - View Single Post

ricecrispi · 02-13-2006, 10:16 PM

Sorry if i didn't clarify.

Reason I stated using two types of tubing is because
1) 3/8" compression fittings on the triple rad
2) the DDC has 3/8" barbs as well so you need adapters for 3/8" tubing to 1/2" tubing to WBs. IT comes with an adapter

The case is SO BIG I dont think you would have problems with any bends in the loop. Go with 1/2"

The new swifftech series WBs are low restriction so you could use 3/8" tubing in the entire loop.
-------------------------------------------------
AS for two pumps. No need for two pumps or software management.

Use thermal shutoff in BIOS. Its available in most nf4 sli boards so if you cpu goes over 60C the comp shutsdown.

DD5/mcp 655 and possibly DDC can also be slightly modded so you can have mobo or fan controller read the rpms off a fan header.

02-13-2006, 10:16 PM	#12
ricecrispi Cooling Savant Join Date: Jul 2005 Location: california Posts: 429	Re: The Dream System: Need Help! Sorry if i didn't clarify. Reason I stated using two types of tubing is because 1) 3/8" compression fittings on the triple rad 2) the DDC has 3/8" barbs as well so you need adapters for 3/8" tubing to 1/2" tubing to WBs. IT comes with an adapter The case is SO BIG I dont think you would have problems with any bends in the loop. Go with 1/2" The new swifftech series WBs are low restriction so you could use 3/8" tubing in the entire loop. ------------------------------------------------- AS for two pumps. No need for two pumps or software management. Use thermal shutoff in BIOS. Its available in most nf4 sli boards so if you cpu goes over 60C the comp shutsdown. DD5/mcp 655 and possibly DDC can also be slightly modded so you can have mobo or fan controller read the rpms off a fan header.