Quote:
|
Originally Posted by TerraMex
I'd wait if marci has a better ideia (he's from the UK),
but the mcp needs a straight adaptor 1/2"-> 3/8" reducer :
http://www.xoxide.com/bl1to3re.html
or smaller, depends o your tubing.
my mcp600 was supplied with two, dunno about the mcp655. |
not sure how it would take the restriction... (mcp 600 used to specifically say not to run with smaller than 3/8" ID tubing/fittings ... the mcp655 just warns against "excessive restriction" (which voids the warranty))
8mm ID sounds pretty restrictive (less than 1/4" ID)
btw is quiet is the aim then an eheim 1048 may be a better bet than a 1250...