Pro/Forums - View Single Post

L3viTy · 02-28-2006, 08:51 AM

Thanks for the reply gmat,
I already hav the rad, Im using is a 1982 jeep heater core, high flow 12inx6in. Should fit 3 120 fans but I will start with two and make a shroud. Case to be used is a supermicro sc750sca, big roomy full server tower. Gutted it and will mod for this specific setup so room isnt an issue. I plan on mounting the rad in the top with blow holes for two fans that will pull air uo through rad from caseone low speed fan in bottom side of case will blow in compleating airflow circuite. As for the powersupply, I already own the thermaltake so Im using it. Reseivoiur is a dual 51/4 in lucite box that will mount in top as well with the pump just below the res.

02-28-2006, 08:51 AM	#3
L3viTy Cooling Neophyte Join Date: Feb 2006 Location: Earth Posts: 4	Re: Help with config for new wc setup Thanks for the reply gmat, I already hav the rad, Im using is a 1982 jeep heater core, high flow 12inx6in. Should fit 3 120 fans but I will start with two and make a shroud. Case to be used is a supermicro sc750sca, big roomy full server tower. Gutted it and will mod for this specific setup so room isnt an issue. I plan on mounting the rad in the top with blow holes for two fans that will pull air uo through rad from caseone low speed fan in bottom side of case will blow in compleating airflow circuite. As for the powersupply, I already own the thermaltake so Im using it. Reseivoiur is a dual 51/4 in lucite box that will mount in top as well with the pump just below the res.