Pro/Forums - View Single Post

L3viTy · 03-03-2006, 03:28 PM

Got all my stuff from Danger Den yesterday. Heres the list.
2 DD TDX blocks
1 Maze4 Chipset block
1 NV68 gpu=ram block
DD-D5 pump
10' 1/2 tubbing
2 pabst 120mm fans
fill port and a small res; will make my own later.

I will be using an ASUS mobo w/2 xeon 3.06 cpu
BFG Gforce 6800 UT/GT/OC hardmodded to a quadro 4000
rad is a jeep heatercore, 11.5x6.5x2 tripple pass
Thermaltake 550w APFC PSU
A bunch of paint and duct tape.

I have made a shroud out of copper plate to confine the fass discharge to the active area of the rad and cut two blow holes in the top of the case where the fans will be mounted sucking air down through the rad into the case/one 120 fan in the bottom as an exhaust.

Pump has to be mounted in the bottom unless problems demand placing it somewhere else. fill port is mounted on top in front about 1/2 in from the side. I plan on running a tube from the fill port to the res then to the pump.

My question is: Sense I have only one rad and two cpu's and a gpu to cool, what is the most efficient way to run the cooling circute? I can get a second rad If I need to but this monstar heater core should do the job if I can get everything else efficiently.
Any sugestions are welcome.
Thanks

Case is a supermicro CSE-762
Height: 26.4" (671mm)
Width: 8.3" (211mm)
Depth: 17.3" (443mm)

03-03-2006, 03:28 PM	#1
L3viTy Cooling Neophyte Join Date: Feb 2006 Location: Earth Posts: 4	routing/sequence sugestions needed. Got all my stuff from Danger Den yesterday. Heres the list. 2 DD TDX blocks 1 Maze4 Chipset block 1 NV68 gpu=ram block DD-D5 pump 10' 1/2 tubbing 2 pabst 120mm fans fill port and a small res; will make my own later. I will be using an ASUS mobo w/2 xeon 3.06 cpu BFG Gforce 6800 UT/GT/OC hardmodded to a quadro 4000 rad is a jeep heatercore, 11.5x6.5x2 tripple pass Thermaltake 550w APFC PSU A bunch of paint and duct tape. I have made a shroud out of copper plate to confine the fass discharge to the active area of the rad and cut two blow holes in the top of the case where the fans will be mounted sucking air down through the rad into the case/one 120 fan in the bottom as an exhaust. Pump has to be mounted in the bottom unless problems demand placing it somewhere else. fill port is mounted on top in front about 1/2 in from the side. I plan on running a tube from the fill port to the res then to the pump. My question is: Sense I have only one rad and two cpu's and a gpu to cool, what is the most efficient way to run the cooling circute? I can get a second rad If I need to but this monstar heater core should do the job if I can get everything else efficiently. Any sugestions are welcome. Thanks Case is a supermicro CSE-762 Height: 26.4" (671mm) Width: 8.3" (211mm) Depth: 17.3" (443mm) Last edited by L3viTy; 03-03-2006 at 04:05 PM.