Pro/Forums - View Single Post

mx · 03-13-2006, 01:19 PM

Thanks stev!

Currently I have the first two solder pads connected to my miniNG.

1) Gnd = Ground
2) Variable motor voltage (Vm) (6 to 12 V, approx 1.0 A max.)

The third pad is connected to my T-balancers analoug sensor hubs flowmeter ports.

3) TACH

I don't really understand how to use the fourth solder pad.

Would there be any advantages using it?

4) Vp = +12 V (runs control circuit, approx., 50 mA max.)

03-13-2006, 01:19 PM	#19
mx Cooling Neophyte Join Date: Oct 2005 Location: Sweden Posts: 73	Re: Varying pump speed possible? Thanks stev! Currently I have the first two solder pads connected to my miniNG. 1) Gnd = Ground 2) Variable motor voltage (Vm) (6 to 12 V, approx 1.0 A max.) The third pad is connected to my T-balancers analoug sensor hubs flowmeter ports. 3) TACH I don't really understand how to use the fourth solder pad. Would there be any advantages using it? 4) Vp = +12 V (runs control circuit, approx., 50 mA max.)