Quote:
|
Originally Posted by phide
I've experienced this in a number of drawing and drafting programs. I couldn't tell you what the 'fix' is (each channel must be horizontally offset by some factor), but I can tell you that it doesn't matter with these tolerances. I don't believe there's any chance of these channels intersecting, and I can say with some degree of certainty that variances in width at different points along the wavy fins are actually a good thing.
|
Ok, but I wan't that they are the same width because it's better to mill them when the channels are the same width.
How small is the headspreader on Athlon 64?