Pro/Forums - View Single Post

masocr79 · 03-19-2006, 06:50 PM

the 18W version is the DDC-1+ 18W .. I guess DD carries it .. that's what I gathered anyway from a thread over at bit-tech ..

.. but I don't think it will work with PWM .. would have to try it out and see ..

would be cool to run two of the 18W DDCs off the miniNG in analogue mode .. but that would exceed the 25W 2 channel max .. but two of the 10W pumps should work in analogue mode though .. still, a single 18W or 10W pump controlled from the miniNG is pretty cool ..

I wonder if you can undervolt the D5 with the miniNG in analogue mode .. instead of the manual rheo .. then you could control via t-ban software config instead ..

mx, you said you had both DDCs hooked up .. are you sure they are the 18W .. cause that would be 36W .. also, you said you connected the third pad on the DDC to one of the analog sensor hubs flow meter pins .. how come not to the RPM signal on the miniNG pins .. ?

03-19-2006, 06:50 PM	#25
masocr79 Cooling Neophyte Join Date: Feb 2006 Location: ny Posts: 8	Re: Varying pump speed possible? the 18W version is the DDC-1+ 18W .. I guess DD carries it .. that's what I gathered anyway from a thread over at bit-tech .. .. but I don't think it will work with PWM .. would have to try it out and see .. would be cool to run two of the 18W DDCs off the miniNG in analogue mode .. but that would exceed the 25W 2 channel max .. but two of the 10W pumps should work in analogue mode though .. still, a single 18W or 10W pump controlled from the miniNG is pretty cool .. I wonder if you can undervolt the D5 with the miniNG in analogue mode .. instead of the manual rheo .. then you could control via t-ban software config instead .. mx, you said you had both DDCs hooked up .. are you sure they are the 18W .. cause that would be 36W .. also, you said you connected the third pad on the DDC to one of the analog sensor hubs flow meter pins .. how come not to the RPM signal on the miniNG pins .. ?