Quote:
|
Originally Posted by masocr79
mx, you gonna rock some tests .. ?
|
I only intend to test heat dump since I don't have the equipment to test flow or head.
Quote:
|
Originally Posted by masocr79
was thinkin it'd be nice to see plexi top vs. inlet flooded top/tank combo .. think it's possible to put a G1.0 threaded barb onto the top of the tank .. can't find anywhere that makes them for G1.0 .. ?
|
Do you mean plexi top /w top mounted inlet vs.
this plexi tank /w a G1" barb on top as inlet? Legris probably makes G1" barbs and they have resellers everywhere that could order one. But would it matter if the inlet is 1" or 1/4" when it ends up in the tank before it goes in to the pump?
Quote:
|
Originally Posted by masocr79
mx, how you structure you circuit with the dual DDC ultras ?
|
I'm not sure how to structure it in my new case. I found that if I use a too short hose between them when connected in series the second pump starts making sounds. If they dump lots of heat I'll probably put both of them before the rad. I'll try a few structures and see which one gives me the lowest cpu temp.