Thanks for the concern. Will this do?
Should suffice for dust and splinters. a cutting disc hurled at 35 000 rpm will get through the mask. But as opposed to a full face mask i can wear that get up for several hours at a time.
Quote:
|
jaydee I agree with Jon, but would love to see you try it. if it fails then you can move on to a different design. Good luck and keep us informed of your progress.
|
I admit my approach i far from time efficient. Yes i have alot of time, and patience (most of the time) . im just going to wing it.
Quote:
|
JFettig All I can say is good luck and I hope you have a LOT of time and a LOT of patients.
|
Patience, but from the pic it could be both.
Quote:
|
jaydee Build first, test later?
|
probably what i will end up doing for the first samples. then ill build and test the addition of each feature. but yeah right now im just in the mood to get going.