Quote:
|
Originally Posted by jman1310
i've read on this site that the 1/4" found on the BPIs is enough
so 1/2" should be better
however
the PA160 has 2-3"
of course that is also converting a 120mm fan to a 160mm rad...
anyway, you should be ok
if you are going to make your own, anything over 2-3" is overkill
jman
|
Sorry but what is "BPIs"? I'm glad to hear that 1/2" should be good enough. Actually it's probably slightly higher than that as the fan blades are mounter on plastic that's at least 2mm thick.
I don't think I'll make my own as the Innovatek one I have now has the shroud permanently mounted on from the factory. I would have to do a lot of metal bending in order to get it off.
Thanks for the suggestion.