Quote:
Originally Posted by Dragon64
IAlso, I checked the port settings on the Cisco 2900 and it is reporting that it is to Full 100. Then when going to the debug page and typing in the command to set the dubplex mode it tells me that the port is already in full duplex mode. Yet, if I look at the network settings it shows 100/Half. Thanks for the response.
|
At least on the 4100, you can't force it into full duplex - you can only force it to *not* go into full-duplex. With a Cisco switch, you want auto-speed and auto-duplex on both the Cisco and the Snap. This should auto-negotiate both to 100/full - if not, unplug the Ethernet cable, wait a bit, and plug it back in to force auto-negotiation.