Pro/Forums - View Single Post

Brad · 02-03-2002, 01:27 AM

fix, if you make one in Cu and one in Al, I'd like to see you send them off to Joe

then we can compare Cu vs Al in both Spir@l and the new block in this thread, we might find that with one design it doesn't matter, while in another design it might be 4C

I'd bet the spir@l wouldn't matter as much because of it's central inlet and how most of the heat is cooled by the coolest water, while in the one in this thread the differance would be a bit more because of the blocks design and how the water is slightly warmed up by the time it gets to the majority of the heat

02-03-2002, 01:27 AM	#10
Brad Thermophile Join Date: Oct 2001 Location: Nuu Zeeelin Posts: 3,175	fix, if you make one in Cu and one in Al, I'd like to see you send them off to Joe then we can compare Cu vs Al in both Spir@l and the new block in this thread, we might find that with one design it doesn't matter, while in another design it might be 4C I'd bet the spir@l wouldn't matter as much because of it's central inlet and how most of the heat is cooled by the coolest water, while in the one in this thread the differance would be a bit more because of the blocks design and how the water is slightly warmed up by the time it gets to the majority of the heat __________________ 2x P3 1100's at 1400, Abit VP6, 2x Corsair 256mb PC150 sticks, 20gb 'cuda ATA-III, 2x 40gb 'cuda ATA-IV in raid 0. 20" Trinitron. No fans 2x 2400+ at 2288mhz (16.0 x 143), Iwill MPX2, 2x Kingmax PC-3200 256mb sticks, 4x 20gb 60gxp in Raid 5 on a Promise SX6000. Asus Ti4200 320/630. Cooled by Water