well i finally sat down and drew out this thing. Baseplate atleast. It looks alot like the G7 for now... but the jets are going to be very different. I'm looking at a suction system directly above the jets, so instead of turbulence outside the cups and restricted flow by the jets towards the output, flow might go up a bit. I don't know yet. Anyways. this took forever to draw... and i might end up redrawing it -_-' If anyone knows how to use proDesktop, please tell me. I'm having quite a hard time with its more advanced features =/. anyways. its not dead center, its off by .2 a mm or so... mostly because i couldn't find a way to link all the jets together as a single object. I'll make the jets, then run it through the wind tunnel and see what results. Does anyone have a suggestion for test system construction? I'd be even more grateful if they drew it out... >.>' turns out that prodesktop is surprisingly difficult for repetitive tasks... duplicate or pattern commands don't allow copies to be later linked up. Or atleast as far as i know. Anyways. heres the baseplate.
The block is also going to be circular, not ovalish like the G7.