View Single Post
Unread 05-25-2006, 07:15 PM   #9
JFettig
Cooling Savant
 
Join Date: Feb 2003
Location: Willmar MN/Fargo ND
Posts: 504
Default Re: GPU Project Block

start milling!

Those radiuses on the inlet and outlets could be chamfered easily with the same effect.

Do you have the mounting holes in it yet?
Make sure you make a backplate for the back of the card.

The tapped holes in the copper plate will have to be done carefully because they arent very deep, so make sure you do a good job and get them started well, I suggest to always tap starting from the opposite side you plan on using so you have for sure good threads.

Jon
JFettig is offline   Reply With Quote