Pro/Forums - View Single Post

RalphW · 05-25-2006, 10:27 PM

Colt357

My pump is rated at 700 L/HR with 3.2M head (AquaXtreme 50Z-DC12 )
Rad is a dual fan heatercore so I should be OK with the waterflow.
I thought about angling the water flow tube where it meets up with the fitting inlet chamber. With a three axis CNC, I can't think of how to do this without using a tilting vise then I run the risk of these tubes not lining up.

jman
I did check that thread but I only see the question of 7800/7900 mounting hole dimensions being asked; no answers are given.
In any case, I already have the mounting dimensions of the graphic cards that I will be using.

05-25-2006, 10:27 PM	#13
RalphW Cooling Neophyte Join Date: Mar 2003 Location: Canada Posts: 32	Re: GPU Project Block Colt357 My pump is rated at 700 L/HR with 3.2M head (AquaXtreme 50Z-DC12 ) Rad is a dual fan heatercore so I should be OK with the waterflow. I thought about angling the water flow tube where it meets up with the fitting inlet chamber. With a three axis CNC, I can't think of how to do this without using a tilting vise then I run the risk of these tubes not lining up. jman I did check that thread but I only see the question of 7800/7900 mounting hole dimensions being asked; no answers are given. In any case, I already have the mounting dimensions of the graphic cards that I will be using. Last edited by RalphW; 05-25-2006 at 10:33 PM.