Pro/Forums - View Single Post - Snap Server 2200 Baby Steps <- Help!

Clique · 05-26-2006, 08:39 AM

Well as I said baby steps. Read many more thread and try numerious options to no avail. So back here seeking more help.

Current situation is as follows:

I have image the snap.bin to both drives (just in case) using the following command: dd if=/mnt/snap1000.bin of=/dev/hdb bs=1024k count=25

It returns in/out totals so I belive all went well.

I have placed the drives back in the Snap Server and regardless of settings the drives to both Master, Master/Slave, both Cable select or just one drive set to Master the results are always the same. ---> System and Disk light Blink in tandem.

Even thought the lights were blinking I tried to allow Assist to locate a Snap Server to no success. (I'm on a 192.168.100.# network) Since I'm not sure of the default Snap Server IP not sure is the workstation running Assist is able to obtain or seek the Snap Server out.

I've tried pressing the reset button with a paperclip 4 times as recommended in another thread and it appears to have no affect. Holding it in does nothing.

The only thing I find a bit strange is that as soon as I plug the power in on the Snap Server it start booting - without me pressing the Power Button.

I'm at a loss at this point as to what to do at this point.

Any help and guaidance is greatly appreciated.

Regards,
Brian

05-26-2006, 08:39 AM	#3
Clique Cooling Neophyte Join Date: May 2006 Location: Grand Island, NY Posts: 5	Re: Snap Server 2200 Baby Steps <- Help! Well as I said baby steps. Read many more thread and try numerious options to no avail. So back here seeking more help. Current situation is as follows: I have image the snap.bin to both drives (just in case) using the following command: dd if=/mnt/snap1000.bin of=/dev/hdb bs=1024k count=25 It returns in/out totals so I belive all went well. I have placed the drives back in the Snap Server and regardless of settings the drives to both Master, Master/Slave, both Cable select or just one drive set to Master the results are always the same. ---> System and Disk light Blink in tandem. Even thought the lights were blinking I tried to allow Assist to locate a Snap Server to no success. (I'm on a 192.168.100.# network) Since I'm not sure of the default Snap Server IP not sure is the workstation running Assist is able to obtain or seek the Snap Server out. I've tried pressing the reset button with a paperclip 4 times as recommended in another thread and it appears to have no affect. Holding it in does nothing. The only thing I find a bit strange is that as soon as I plug the power in on the Snap Server it start booting - without me pressing the Power Button. I'm at a loss at this point as to what to do at this point. Any help and guaidance is greatly appreciated. Regards, Brian