View Single Post
Unread 06-04-2006, 06:17 PM   #2
Long Haired Git
Cooling Savant
 
Long Haired Git's Avatar
 
Join Date: Jan 2003
Location: Sydney, Oz
Posts: 336
Default Re: not sure if my W/C circuit config is OK?

If both barbs are submersed in the reservoir, then the relative altitude of the reservoir is inconsequential.
I strongly advise the reservoir to be located immediately prior to the pump, with the shortest run of the largest diameter tubing and barbs you can handle. You've modded the MCP for precisely the same reasons as this recommendation.

Putting the reservoir where you have it should be OK. It will now introduce restriction where-as prior to the pump it is largely neutral. The pump will now be sucking through the radiator which our pumps hate. Otherwise, if the radiator is restrictive enough, it will cause the reservoir to be a pressurised component and thus it needs to be leak proof to a couple of PSI.

Best avoided.
__________________
Long Haired Git
"Securing an environment of Windows platforms from abuse - external or internal - is akin to trying to install sprinklers in a fireworks factory where smoking on the job is permitted." (Prof. Gene Spafford)
My Rig, in all its glory, can be seen best here
AMD XP1600 @ 1530 Mhz | Soyo Dragon + | 256 Mb PC2700 DDRAM | 2 x 40 Gb 7200rpm in Raid-0 | Maze 2, eheim 1250, dual heater cores! | Full specifications (PCDB)

Long Haired Git is offline   Reply With Quote