[Shootingblanks]

Well I have decided to go back to watercooling. All I need to do now is finalize the components that I am planning on purchasing. I currently have the Swiftech Storm CPU Block, Danger Den Fillport, OCZ BGA Ramsinks, and a Swiftech MCRES-MICRO Small Form Factor Reservoir. The parts I need are the following:

Low Profile Acetal Maze4GPU
12V DD-D5 Pump
Thermochill PA120.2 or 120.3
20 ft of Tygon Tubing
CM Stacker Bottom Case Shroud

The way I have my Stacker configured I am planning on the radiator placement on the bottom of the case with the bottom case shroud availabe at danger den. Currently I will be cooling my cpu and gpu. Will the Thermochill be sufficient enought to cool the processor and the gpu on the 7800GTX KO edition card? Another thing I need to take into consideration is the feasibility of the 120.2 if I acquire another 7800GTX to run in SLI in the near future. If I were to add another 7800GTX, will the 120.2 still be up to the task of sufficiently cooling all these components? If not, I could possibly purchase a Thermochill PA120.1 and mount it one the 120mm fan on the rear of the case and run both radiators. Would this scenario work? A Thermochill PA120.3 would be one tight fit on the bottom of this case with some modifications. I have seen it on a few post, but I really dont want to hack up this case if I can get by with a 120.2.