Pro/Forums - View Single Post

Szandor · 06-22-2006, 04:41 PM

514 L/hr @6" head using 18" long X 1/2" ID ClearFlex tubing on high flow 1/2" barbs on inlet & outlet

Pump runs quiet & cool after short 1/2 hr test

It had a few burrs on the impeller & in outlet housing that needed to be removed

Outlet housing only has a 6mm ID opening at bottom of threaded section. Look at outlet barb in the 3rd picture @DD & you can just make it out

I'll update again after its installed

Regards, Szandor

06-22-2006, 04:41 PM	#6
Szandor Cooling Neophyte Join Date: Mar 2003 Location: Massachusetts U.S.A. Posts: 24	Re: csp mag 3? 514 L/hr @6" head using 18" long X 1/2" ID ClearFlex tubing on high flow 1/2" barbs on inlet & outlet Pump runs quiet & cool after short 1/2 hr test It had a few burrs on the impeller & in outlet housing that needed to be removed Outlet housing only has a 6mm ID opening at bottom of threaded section. Look at outlet barb in the 3rd picture @DD & you can just make it out I'll update again after its installed Regards, Szandor