Pro/Forums - View Single Post

Phoenix32 · 09-06-2006, 12:11 AM

That place you were talking about (I had the link and checked them after you reminded me) had the front bezel for $25. No drive plates tho. How complex is the drive plate? The 4000 Drive mounts hold 2 drives each and are pretty basic (easy to duplicate if you have to). Also, is the bottom of the case flat? If so, maybe some stand-offs and new holes drilled in the bottom of the case, then mount directly to the case? It would not be moved around at all, but being a hardware kinda guy, not mounting a hard drive gives me the willy's.

On the same note, sorta, anyone know where a guy could get drive sleds (caddy) for a SNAP 4200/4500 without buying the drive with it (from adaptec)?

09-06-2006, 12:11 AM	#3
Phoenix32 Thermophile Join Date: May 2006 Location: Yakima, WA Posts: 1,282	Re: 4100 Parts? That place you were talking about (I had the link and checked them after you reminded me) had the front bezel for $25. No drive plates tho. How complex is the drive plate? The 4000 Drive mounts hold 2 drives each and are pretty basic (easy to duplicate if you have to). Also, is the bottom of the case flat? If so, maybe some stand-offs and new holes drilled in the bottom of the case, then mount directly to the case? It would not be moved around at all, but being a hardware kinda guy, not mounting a hard drive gives me the willy's. On the same note, sorta, anyone know where a guy could get drive sleds (caddy) for a SNAP 4200/4500 without buying the drive with it (from adaptec)?