Quote:
Originally posted by jaydee116
I think you will run out of room. I don't have tooling to do those small passes. Maybe Fixittt can figure that one out. Might make a good addition to his original Spiral.
|
The split flow spiral Scythe posted would take right at 2" as shown using 1/8" channels and 30mil wall thickness between channels, a .375" center circular chamber and an outermost wall thickness of 67.5 mils
Even if you don't split the channels in two, the concept of splitting the flow two ways is a good one. Maybe later I'll do up a drawing and show why from a thermal standpoint...
(wanders back off into the blue)