Quote:
Originally posted by Brad
jaydee, what do you think of my top left design on that block? Is it doable with your mill?
Also, I'm not worried about length, my iwill will have room for a 100mm x 50mm block.....
|
The mill can do it but I am not sure I am capable of coming up with the code to do it. That will be a nightmare to try and get to work right. It would take several hours to mill as the bit is so small not even the bigger mills would be able to go any faster do to the fragile bit. I am having no luck finding a endmill that will mill Al under 1/8" so far. I have a few other places to check yet.
Very nice design though, maybe a more capable code writer can figure that one out.