Pro/Forums - View Single Post - Bunna o-ring channel depth??

jaydee · 01-28-2007, 09:19 PM

I have always used 75%. If that does not work then there maybe something wrong with your mounting system or an inconsistent O-ring groove or flatness of the material the groove is going in. Make sure your bolt pattern holding the 2 pieces together is not spread to far apart to cause the o-ring to bend the material you are trying to seal. Had that problem on a few water blocks. Simple solution add more bolts.

Without knowing the specs of what you are doing we can not limit the problem to just the channel depth.

01-28-2007, 09:19 PM	#10
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Re: Bunna o-ring channel depth?? I have always used 75%. If that does not work then there maybe something wrong with your mounting system or an inconsistent O-ring groove or flatness of the material the groove is going in. Make sure your bolt pattern holding the 2 pieces together is not spread to far apart to cause the o-ring to bend the material you are trying to seal. Had that problem on a few water blocks. Simple solution add more bolts. Without knowing the specs of what you are doing we can not limit the problem to just the channel depth.