Quote:
|
Originally Posted by blue68f100
Have you reset the 4100 back to factory settings?
I assume you are not getting any disk led on the front panel.
I have dropped a note to Snap-tech, he will know what it is.
Did you keep the previous attemp? Want to see if its the devices are same, dev=0xC0002 & dev=0x80002.
|
After upgrading the OS, this is the new log. Still the same devices and at the same point in the rebuild.
RAID5Resync on array 0: 37% done
01/29/2007 19:37:53 20 D SYS | DISK: req=0x3A9B2F8 dev=0xC0002 fn=1 blk=0x6065180 sts=16
01/29/2007 19:37:54 20 D SYS | IDE: A 48 bit LBA capable Hard Drive was detected ...
01/29/2007 19:37:54 20 D SYS | IDE: 48 bit LBA is not supported on 4100 and 12000 platforms.
01/29/2007 19:37:54 20 D SYS | IDE: Setting the hard drive size to maximum addressable by 28 bits: 131071 MBytes.
01/29/2007 19:37:56 20 D SYS | DISK: req=0x3A9B2F8 dev=0xC0002 fn=1 blk=0x6065180 sts=16
01/29/2007 19:37:56 20 D SYS | IDE: A 48 bit LBA capable Hard Drive was detected ...
01/29/2007 19:37:56 20 D SYS | IDE: 48 bit LBA is not supported on 4100 and 12000 platforms.
01/29/2007 19:37:56 20 D SYS | IDE: Setting the hard drive size to maximum addressable by 28 bits: 131071 MBytes.
01/29/2007 19:37:56 20 D SYS | DISK: req=0x3A9B2F8 dev=0x80002 fn=1 blk=0x6065180 sts=16
01/29/2007 19:37:56 20 D SYS | RAID5Resync on array 0: read to cache failed (16)
01/29/2007 19:37:57 20 D SYS | RAID5Resync on array 0: failed
01/29/2007 19:37:57 20 E L01 | File System : Failed to resynchronize logical set 60000, error -1