View Single Post
Unread 06-02-2001, 01:01 PM   #12
dijinn
Cooling Neophyte
 
Join Date: Jun 2001
Location: New York, NY
Posts: 5
Default

Matt-

I was debating getting one of those jagged edge blocks or one of the DangerDen Maze1 blocks. Reason was it was goin gon my PIII and not for a T-bird.

Anyway, I opted for the Maze1 because although the sizes of the two blocks were the same (roughly 2x2x5/8) and the jagged edge block has those neat jagged channels, the fittings on the jagged channel used 1/8"NPT on the threaded end. The Maze1 uses 1/4"NPT on the threaded end and since my system is 1/2", I can order the Maze1 with 1/2" fittings as an option.

I spoke with someone over at Becooling about their block (can't recall the name) and they said that it would be possible to replace the 1/8"NPT with 1/4"NPT but they wouldn't do it and it definately would require some boring out of the old hole.

So, that's why I opted for the DangerDen block because I would rather not have the 1/8" bottle-neck in my 1/2" setup.

Anyway, that was probably more than you wanted to know...

- J.
dijinn is offline   Reply With Quote