Pro/Forums - View Single Post - Problems with failure on a 2000 model in mirror mode

dunkz · 03-23-2007, 07:57 AM

Well currently I can't get to the UI because it is stuck in a permanent reboot state. Which drive configuration should I go back to? The original where it failed or new drive with the failure drive configuration? Both allowed the system to remain responsive.

The one causing the reboots is the new drive + the old one that didn't fail as far as I can tell.

The drives are all the same capacity, and none have any master/slave settings on the jumpers set.

I did not do the firmware updates myself it was purchased with this done already.

Thanks!
-Greg

03-23-2007, 07:57 AM	#3
dunkz Cooling Neophyte Join Date: Mar 2007 Location: NH, USA Posts: 9	Re: Problems with failure on a 2000 model in mirror mode Well currently I can't get to the UI because it is stuck in a permanent reboot state. Which drive configuration should I go back to? The original where it failed or new drive with the failure drive configuration? Both allowed the system to remain responsive. The one causing the reboots is the new drive + the old one that didn't fail as far as I can tell. The drives are all the same capacity, and none have any master/slave settings on the jumpers set. I did not do the firmware updates myself it was purchased with this done already. Thanks! -Greg