Pro/Forums - View Single Post - logical set 60000, error -1

ShrewLWD · 03-30-2007, 09:36 AM

Hi everyone,

I have a 4100 (4.0.860, HW 2.2.1, BIOS 2.4.437) that was in RAID 5 (4x120Gig Maxtor). One of the drives crashed, so I shipped it off to Adaptec. They sent me a 160gig WD. When it rebuilds, I get the 60000 error -1 message.
In the log its;
File System: Failed to resynchronize logical set 60000 Disk 60000

When I run in lo p -1 it shows it gets to 71% done on RAID5Resync then shows 3 identical lines;
DISK: req=0x515EC60 dev=0xc0003 fn=1 blk=0xA39AD70 sts=20
DISK: req=0x515EC60 dev=0xc0003 fn=1 blk=0xA39AD70 sts=20
DISK: req=0x515EC60 dev=0xc0003 fn=1 blk=0xA39AD70 sts=20

followed by;
read to cache failed (20)

in de shows all 4 drives with their respective assigned names; 10007, 1000F, 10017, 1001F but no errors or issues.

What am I missing here to determine a) if it's a drive issue and therefore b) which drive?

I shut it down and reboot it, which causes it to go through its 4+ hours of resyncing, but it still stops at 71%

Any assistance would be appreciated!

UPDATE: This thread discusses it, and it appears dev=0xc0003 means drive 3? That's the replacement drive they sent me.

03-30-2007, 09:36 AM	#21
ShrewLWD Cooling Neophyte Join Date: Mar 2007 Location: MN, USA Posts: 19	Re: logical set 60000, error -1 Hi everyone, I have a 4100 (4.0.860, HW 2.2.1, BIOS 2.4.437) that was in RAID 5 (4x120Gig Maxtor). One of the drives crashed, so I shipped it off to Adaptec. They sent me a 160gig WD. When it rebuilds, I get the 60000 error -1 message. In the log its; File System: Failed to resynchronize logical set 60000 Disk 60000 When I run in lo p -1 it shows it gets to 71% done on RAID5Resync then shows 3 identical lines; DISK: req=0x515EC60 dev=0xc0003 fn=1 blk=0xA39AD70 sts=20 DISK: req=0x515EC60 dev=0xc0003 fn=1 blk=0xA39AD70 sts=20 DISK: req=0x515EC60 dev=0xc0003 fn=1 blk=0xA39AD70 sts=20 followed by; read to cache failed (20) in de shows all 4 drives with their respective assigned names; 10007, 1000F, 10017, 1001F but no errors or issues. What am I missing here to determine a) if it's a drive issue and therefore b) which drive? I shut it down and reboot it, which causes it to go through its 4+ hours of resyncing, but it still stops at 71% Any assistance would be appreciated! UPDATE: This thread discusses it, and it appears dev=0xc0003 means drive 3? That's the replacement drive they sent me. Last edited by ShrewLWD; 03-30-2007 at 09:58 AM.