Quote:
|
Originally Posted by blue68f100
Re check all of the jumpers on the drives, Drive 1.
All should be set to MASTER or Single Drive.
|
Hmmmm, all of my Guardian units are set as c/s???
Quote:
|
Originally Posted by blue68f100
When you install the OS, only have drive 1 in the 14000. Once the OS has been installed, then hot mount the HD's.
Generally Snap number's their drives from left to right.
Open the unit up and look. You should find a label marking the drive positions.
|
Agreed, boot it with only drive 1 installed, then hot swap the rest in after you get the unit up and running good.
I am not sure 100%, but I believe David is right, drive 1 should be the left most hard disk. There may also be a map of the drives inside the unit on the top cover.