Quote:
|
Originally Posted by bigben2k
The #Rotor block is a good candidate, if you have a drill press.
Search in here.
|
#Rotor design is for TEC cooling. I am thinking of using #Rotor design with my own 'ring' design. It would also avail Owen’s idea.
I am thinking of drilling holes in center of the block. This would result in design similar to #Rotor except that holes/pins would be limited (thus concentrating on CPU core only). I would cut out the metals between holes so that water flows in it (Owen’s design).
An exit would be located at one end what would take away the water from the holes/pins formed. The exit would be linked to ‘rings’.
Ring(s) would take away water from these pins and circulate it in the block before exit. (Similar to my Al WB).
Questions:
a) For ring construction, can I use hole saw?
b) Can I connect holes (pins) by drilling i.e. drill out the barrier using drill bit?