Pro/Forums - View Single Post - 4100 problem

TheShawnThomas · 07-15-2007, 04:48 PM

sound about right. so before taking apart both servers to swap power supplies I tried swapping power leads between drives and the system didn't keep spinning the fans continuously so I hooked everything up like normal and the system decided to boot... I swear I reconnected the stupid cable 3 times to make sure it was plugged in correctly. sigh.

So anyway it boots and drive 4 still mounts and is available but now it shows "Logical set member 2 not found" which you say is disk 3. So I'm leaning towards bad disk but I will still try swapping power supplies.

If it is the same with the other power supply I will order another drive that is as close to the same specs. If I can get this working again I will reconfigure for RAID 5. Can I start it with 3 drives and when I get the 4th just add it to the set? or should I wait until I get the replacement drive?

Thanks again.

07-15-2007, 04:48 PM	#8
TheShawnThomas Cooling Neophyte Join Date: Jul 2007 Location: N Palm Beach, FL Posts: 9	Re: 4100 problem - HDD bad? sound about right. so before taking apart both servers to swap power supplies I tried swapping power leads between drives and the system didn't keep spinning the fans continuously so I hooked everything up like normal and the system decided to boot... I swear I reconnected the stupid cable 3 times to make sure it was plugged in correctly. sigh. So anyway it boots and drive 4 still mounts and is available but now it shows "Logical set member 2 not found" which you say is disk 3. So I'm leaning towards bad disk but I will still try swapping power supplies. If it is the same with the other power supply I will order another drive that is as close to the same specs. If I can get this working again I will reconfigure for RAID 5. Can I start it with 3 drives and when I get the 4th just add it to the set? or should I wait until I get the replacement drive? Thanks again.